[Hansen2012] "Evaluation of single column trapping/separation and chemiluminescence detection for measurement of methanethiol and dimethyl sulfide from pig production.",
J Anal Methods Chem
, vol. 2012: Department of Engineering, Science and Technology, Aarhus University, Blichers AllÃ© 20, 8830 Tjele, Denmark., pp. 489239, 2012.
Reduced sulfur compounds are considered to be important odorants from pig production due to their low odor threshold values and low solubility in slurry. The objective of the present study was to investigate the use of a portable method with a single silica gel column for trapping/separation coupled with chemiluminescence detection (SCTS-CL) for measurement of methanethiol and dimethyl sulfide in sample air from pig production. Proton-transfer-reaction mass spectrometry (PTR-MS) was used to evaluate the trapping/separation. The silica gel column used for the SCTS-CL efficiently collected hydrogen sulfide, methanethiol and dimethyl sulfide. The measurement of methanethiol by SCTS-CL was clearly interfered by the high concentration of hydrogen sulfide found in pig production, and a removal of hydrogen sulfide was necessary to obtain reliable results. Air samples taken from a facility with growing-finishing pigs were analyzed by SCTS-CL, PTR-MS, and a gas chromatograph with sulfur chemiluminescence detection (GC-SCD) to evaluate the SCTS-CL. The difference between the concentrations of methanethiol and dimethyl sulfide measured with SCTS-CL, PTR-MS, and GC-SCD was below 10%. In conclusion, the SCTS-CL is a portable and low-cost alternative to the commercial methods that can be used to measure methanethiol and dimethyl sulfide in sample air from pig production.
[Andersen2012] "Minimisation of artefact formation of dimethyl disulphide during sampling and analysis of methanethiol in air using solid sorbent materials.",
J Chromatogr A
, vol. 1245: Applied Plasma Physics AS, Bedriftsveien 25, PO Box 584, 4305 Sandnes, Norway., pp. 24–31, Jul, 2012.
Methanethiol (MT) is a potent odorant that can be difficult to measure due to its high volatility and reactivity; it easily reacts to form dimethyl disulphide (DMDS) during sampling and/or analysis. This paper focuses on finding an optimal method for sampling and measuring MT with minimum artefact formation using sorbent materials and a thermal desorption-gas chromatography-mass spectrometry method (TD-GC-MS). Experiments were conducted to identify suitable sorbent materials and tubes for analysis. Breakthrough, desorption rate, the effects of storage and desorption temperatures were investigated and different drying methods were established with respect to quantitative sampling and formation of DMDS. Proton-transfer-reaction mass spectrometry (PTR-MS) was used in the development of the method and was an especially useful tool for determination of breakthrough. The results show that glass tubes packed with silica gel for pre-concentration of MT before analysis with TD-GC-MS give the best results. In addition, a combination of Tenax TA and carbonised molecular sieve or Tenax TA cooled to 0 °C gives acceptable results. 80 °C was found to be the optimal desorption temperature. For all the sampling methods tested, storage conditions were observed to be very critical for transformation of MT. Room temperature storage should be limited to few minutes and, in general, tubes should be kept at 0Â°C or lower during storage.